Hardware appliance

After removing the Endpoint Analytics hardware appliance from its packaging, verify that all accompanying accessories (rackmount kit, appliance-locking bezel and keys, and power cord) are included. The appliance can be mounted in a standard 19-inch rack or cabinet.

Important

If your box arrives torn, dented, or otherwise damaged, the appliance itself seems damaged, or there are missing parts, contact Plixer Technical Support immediately and do not attempt to install the unit.

  1. Connect the power cable to the socket in the rear of the appliance and plug the other end into a grounded AC outlet.

  2. Connect a monitor, keyboard, and mouse directly to the appliance or through a KVM switch.

Hint

A PC running HyperTerminal can also be used to access the appliance’s command line interface (CLI) using serial parameters: 9600 baud, N, 8, and 1.

  1. Connect an RJ-45 Ethernet cable to the port labeled e0:Mgt behind the appliance and connect the other end of the cable to an available switch port.

  2. Connect the monitoring interface(s) to the network switch ports. The second on-board copper port and additional ports in the expansion slots can be used as additional monitor ports for the system.

  3. Power on the device using the button on the front panel and use the LEDs to confirm connectivity based on the following table:

    LED

    State

    Connectivity status

    Left

    Off

    No network connection (Link Down)

    Solid amber

    Network link established (Link Up)

    Blinking amber

    Transmit/receive activity

    Right

    Off

    10 Mbps connection (if left LED is on or blinking)

    Solid amber

    100 Mbps connection

    Solid Green

    1000 Mbps connection

Once the appliance boots, wait for the login prompt, and then follow the initial configuration guide to complete the appliance deployment.